Step 20: Complete Headset Software Installation

Introduction

This step provides instructions on installing the software for the HTC Focus Headset.

Info

The information below covers the process of the Controller with Wrist Tracker when completing the Headset Software installation. If you are operating the Controller with Hand Tracker, the process is identical, however, the images may be different.

Time Required

~10mins per headset

Tools & Equipment Required

• HTC Vive Headset
• Hand Tracker / Wrist Tracker
• USB-C Cable

---

On this page:

  Install the Zero Latency Software onto the Headset

---

Install the Zero Latency Software onto the Headset

• On the Launcher, hover over Settings and select the Hardware Setup tool from the dropdown.

• Click on Setup Headset.

• Connect the headset via the USB-C cable connected to the Game Master PC, then turn on the headset by holding the power button for 3 seconds. 

Danger

If the initial Firmware installation has not been completed prior to this step, you will encounter issues with the headset.

• Click the Start Setup button and press Next to confirm you have installed the Firmware.

During the Software installation, the headset may reboot. Please do not disconnect the headset during this time.

• When prompted, select the Number from the dropdown that is the same as what is applied to the front of the headset, then press Next. 

Info

The below steps are for Controller with Wrist tracker. For the Controller with hand Tracker Pairing, this step can be skipped and actioned once the remaining steps below have been completed.

The following is the guide on how to pair the Controller with Hand Tracker - How do I Pair the Hand Tracker?

• Follow the on-screen instructions and press the Activate headset listening when ready to pair.

• Using the button combination as stated on the Headset Setup menu, pair the wrist tracker.

• Press Done once the wrist tracker has been paired.

• The headset setup should now state it's complete, press Reboot Headset to complete the process. 

• Close the Headset Setup menu and select Hardware.

• Confirm the headset appears as an option under 'Active', 'Standby' or 'Reserve'.

Info

The headset may not appear straight away. If it has not appeared after 2 minutes, restart the headset.

• Once confirmed, the headset can be turned off by holding the power button for 10 seconds. 

  Back to top

Article Keywords/Phrases: 
Install ZL software
Software installation